R1200 ST windshields are designed with more height than
the OEM shield, which enhances the upper torso and helmet
protection for the rider. These windshields also offer full
widths, with no “V” channel in the shield.
standard OEM shield measures approximately 4” high from the
headlight cutout to the top of the “V” cut. The width on this
shield at the top is approximately 14”, but has the cut out in
the middle so there is minimal protection at the cutout.
area shield for the ST has a standard “domed” shape, is 12.5”
from the headlight cutout to the top of the shield, and is
approximately 17” wide at the top of the shield. This shield
is made from thicker .187 aircraft grade acrylic, and
predrilled to fit the ST. Removal and replacement takes about
5 minutes. The shield has hand polished edges and retains the
stock up and down feature.
cut shield has a little less height at the middle than the
“domed” shield, and the top cut is shaped like an inverted
“domed” cut. This shield is approximately 11” in height, when
measured from the headlight cutout, and the width at the top
is a little more than 15”, when measured from the left and
right top apexes. This shield is mildly quieter than the
standard domed top, and offers more ability to see over the
shield for shorter riders.
offer an exact size & shape as the OEM shield in dark
gray, which complements some of the colors on the bike. This
shield is also .187, aircraft grade acrylic.
measuring purposes, please take a measuring tape and from the
headlight cutout, go up to simulate the heights of the shield.
At that point, you can do the same with the width for sizing
purposes. This will give you a general idea of the size of
each shield. The shields are available in three different
tints and clear. TINTS: LIGHT
GRAY, LIGHT BLUE, LIGHT GREEN